No Products in the Cart
It can be used with MTL coils for freebase or nic salt vape liquids, or it can be used with DTL coils for anything else like shortfills at up to 40watts for a nice intermediate sub ohm vape.
1 x RPM40 Device (1500mAh)
1 x RPM Standard Pod ( RPM Mesh 0.4ohm Coil Preinstalled) (2ml)
1 x RPM Nord Pod (Nord DC 0.6ohmCoil Preinstalled) (2ml)
1 x cable
1 x User Manual
The RPM40 Pod Kit is compatible with two different pod types and in-turn various coils
The RPM 40 RPM POD uses the Smok RPM Coils which are available in 1.0 Ohm for Mouth to Lung vaping and a similar draw to a cigarette. You would need to set your device to a maximum of 15w
Or the Smok RPM Coils in 0.4 Ohm for an intermediate sub ohm vaping experience with more clouds, vapor and flavour. When using these coils set your device to a maximum 25W
For the Smok RPM Coils in 0.4 Ohm we would recommend any liquid that's at least 60%VG/40%PG. When sub-ohm vaping with lower resistance coils, we would recommend using e-liquids with a nicotine strength no higher than 3mg as the effect of higher nicotine can be a bit harsh on the throat. Why not try a high VG shortfill which can be mixed up to 3mg nicotine strength.
If you are using the Smok RPM Coils in 0.4Ohm and would still like a higher nicotine strength we would recommend a High VG 10ml Liquid to avoid the device leaking. These are available in higher nicotine strengths, but please note that these may be quite strong when sub-ohm vaping.
Size: 25 x 25 x 99 mm
Battery Capacity: 1500mAh built-in
E-Juice Capacity: 2ml
Input Voltage: 3.3V-4.2V
Output Voltage: 0.5V-4.1V
Firing Time: 0.001S
Output Wattage: 1W-40W
Output Mode: Watt
Resistance Range: 0.2ohm - 2.5ohm
The maximum output power is 40W, which is powered by an internal 1500mAh Battery
You will be able to see the current battery levels of your RPM40 Kit on the digital Full Colour Display screen on the front of the device.
This is a soide filling pod device so you will need to remove the pod to fill with e-liquid
Pull out the pod
Pull out the rubber plug on the side of the pod and add e-liquid through the slot
Press the rubber plug back carefully and firmly. When filling the pod for the first time, please let the device stand for 2-3 minutes to prime the coil.